C 240 Wagon (203.261) V6-2.6L (112.912) (2003)
/v6-2.6l_(112.912)/Page-938003.png)
Test specifications for pistons
Shown on engine 112
The pistons marked with an "x" must only be installed in the cylinder bores likewise marked with 'x'.
1
The piston diameter on engines 112, 113 is stated in two tolerances. The two tolerances of the piston diameters are distinguished one from the
other by the letters "x" and "(x)".
The marking is located on the top of the piston crown.
Shown on engine 112
2
The cylinder bore diameter on engines 112, 113 is stated in two tolerances. The two tolerances of the cylinder bore diameters are distinguished one
from the other by the letters "x" and "(x)".
The marking is located at the bottom right on the crankcase at the mount for the engine support.
