C 320 CL (203.764) V6-3.2L (112.946) (2004)
Brake Caliper: Service and Repair
AR42.10-P-0080P Remove/Install Rear Axle Brake Caliper
Remove/Install Rear Axle Brake Caliper
Remove/Install
DANGER:
-
Risk of death. Death may result if vehicle slips or topples from the lifting platform.
-
Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by
the vehicle manufacturer.
-
Risk of poisoning from swallowing brake fluid. Risk of injury from brake fluid coming into contact with skin and eyes.
-
Pour brake fluid only into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling
brake fluid.
CAUTION:
-
See brake fluid notes
-
See notes on repairs to brake system
-
See notes on installing brake hoses
1
Remove rear wheels
2
Disconnect brake hose (51) first from brake line (5) and then from fixed caliper (31)
NOTE: Seal off line connections immediately with plugs. The brake fluid reservoir must not be allowed to empty completely.
CAUTION: See notes on installing brake hoses
3
Unscrew fixed caliper (31) from wheel carrier
NOTE: Installation: Install new micro-encapsulated bolts (31a).
4
Install in the reverse order
5
Bleed brake system.
Inspect
DANGER:
-
Risk of accident when the vehicle is first operated following repair work due to inadequate braking effect the first time the service brake
is applied.
-
Before starting engine, actuate brake pedal several times until the pressure is built up and maintained in the brake system.