C 320 CL (203.764) V6-3.2L (112.946) (2004)
Task
The glow pin ignites the fuel/air mixture when heater operation is started.
Triggering Heater Mode With Remote Control
Triggering Heater Mode With Radio Remote Control Immediately - Function
Shown On Models 215, 220
Operating procedure
1
Basic requirements:
-
Ignition (terminal 15) OFF.
2
The "ON" button on the STH radio remote control transmitter (A8/3) was used to activate heater operation.
3
The CTEL antenna (A2/22 or A2/49a1) registers the cut-in signal and forwards it to the STH radio remote control receiver (A6/1).
NOTE: In vehicles with a telephone, the cut-in signal acquired by the CTEL antenna (A2/22 or A2/49a1) is forwarded via an antenna splitter to
the STH radio remote control receiver (A6/1).