C 320 CL (203.764) V6-3.2L (112.946) (2004)
Fuse Block: Service and Repair
AR54.15-P-1310P Remove/Install Driver's Side Interior Fuse Box
AR54.15-P-1310P Remove/Install Driver's Side Interior Fuse Box
DANGER:
Risk of explosion from gas Risk of poisoning and caustic burns from swallowing battery electrolyte Risk of injury from caustic burns to eyes
and skin from battery electrolyte or from handling damaged lead-acid batteries
-
No fire, sparks, naked flames or smoking
-
Wear acid-resistant gloves, clothing and eye protection Pour battery electrolyte only into suitable and appropriately marked containers
1
Disconnect ground cable of battery
CAUTION: Do not connect quiescent current retention device
2
Unclip side cover (1) (direction of arrow) and take off
NOTE: Installation: Ensure the guides are correctly located
3
Unplug fuses
-
Fuse assignment as-built configuration
4
Unscrew screws (2)
See "Special Tools - Torx bit set" given below.
5
Remove interior fuse box (F34)
6
Unscrew nut (3)
7
Take off cable of circuit 30 of interior fuse box (F34)
8
Release contact receptacles and pull out of interior fuse box (F34)
CAUTION: Release carefully to avoid damaging
Installation:
Note installed position of cables (mark for identification) Ensure that the female contacts are correctly locked.
See "Special Tools - Release tool for SPT/JPT contacts" given below"
9
Install in the reverse order.