C 350 (204.056) V6-3.5L (272.961) (2008)
4
Remove sensor (020a) from front propeller shaft (1).
Ready screen for angle 3
Component Identification
Measurement - Angle 3: rear propeller shaft
5
Clean contact surfaces for sensor (020a) on rear propeller shaft (2).
6
Position sensor (020a) horizontally on rear propeller shaft (2) and press on firmly.
The spiral cable (020b) of the sensor (020a) must point in the direction of travel for each measurement. Otherwise the measurement will be
inaccurate.
If the sensor (020a) is not positioned horizontally on the rear propeller shaft (2), the error message "Y-positional error - sensor ?7 appears on the
display. The measured angle cannot be saved.
Illustration shows model 211 with engine 112
Component Identification
Illustration shows model 211 with engine 647
Measurement values screen for angle 3
The value measured is shown on the display.
7
Press SAVE button.
The values are saved.