C 350 (204.056) V6-3.5L (272.961) (2008)
Component Identification
Shown: model 211 with 210 mm dia. rear axle center assembly (210E)
Measured values screen for angle 4
The meter is ready to take a measurement. The value measured is shown on the display.
7
Press SAVE button.
The values are saved.
Measured values screen for angle 4, display e.g. 2.68 degrees
Confirmation screen
A confirmation message appears briefly and then the meter indicates that it is ready to measure the next angle (angle 5). The measurement is
completed and stored in memory.
8
Remove sensor (020a) from rear axle center assembly.
9
Remove rear axle center assembly adapter (020h).
10
Detach sensor mount (020c) from sensor (020a).
Confirmation screen
AR41.10-P-0086-01R Read Out Propeller Shaft Inclination Angles From Memory; Correct If
Necessary
AR41.10-P-0086-01R Read out propeller shaft inclination angles from memory; correct if necessary