C 55 AMG (203.076) V8-5.5L (113.988) (2006)
Rear Knuckle Alignment Link: Service and Repair
AR35.20-P-0112P Remove/Install Track Rod, Replace Rubber Mount
- except CODE (P98) Black Series [model 209]
Work Instructions
DANGER:
-
Risk of fatal accident from vehicle slipping or toppling off the lift platform
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer.
CAUTION: Installation: replace self-locking bolts and nuts.
NOTE: Check rear axle tracking and adjust if necessary
4
Tie rod
CAUTION: Do not damage rubber sleeve when removing.
NOTE:
-
When tightening nuts of track rod at rear axle carrier, move rear axle shaft to approximately horizontal position.
-
Clean grease off ball head bolt and beveled seat in wheel carrier.
-
Press ball head bolt into cone, hold with Allen wrench if necessary
4a Cam bolt, eccentric disk
NOTE: Installed position: Mark eccentric disk relative to rear axle carrier (arrow)
4B Rubber mount on track rod
-
If necessary after checking: Remove and install rubber mount on track rod.
6k Torsion bar connecting rod, remove, install