CL 55 AMG (215.374) V8-5.5L SC (113.991) (2004)
-
Measurement position "A" (x): 140 mm
-
Front: lower than outer roof surface: 0 - 1 mm
-
Rear: higher than outer roof surface: 0 - 1 mm
11
Tighten torx bolts (5)
-
Bolt, tilting/sliding roof panel to tilting bracket mount: 4 Nm
NOTE:
-
First tighten the rear bolt and then the front bolt on one side only. Repeat this procedure on the opposite side.
-
When tightening the rear bolts, press towards the rear and slightly downwards with the screwdriver (arrows).
12
Check tilting/sliding roof for proper function and fit
13
Install in the reverse order
NOTE: If there is wind noise, Adjust seal on tilting/sliding roof panel.
Special Tools
Torx Bit Set P/N # 000 589 01 10 00