CL 55 AMG (215.374) V8-5.5L SC (113.991) (2004)
Wheel Speed Sensor: Service and Repair
AR42.40-P-0820I Remove/Install Left or Right Rear Axle Speed Sensor
Shown On Model 220
Removal
1. Unscrew fixing bolt (6a) retaining rear left and/or right wheel speed sensors
2. Remove rear left and right wheel speed sensors.(L6/3, L6/4)
3. Pull rubber grommet (3) over wheel speed sensor connectors (L6/3x1, L6/4x1)
-
In addition, unscrew nuts (1) and remove cover (2) on left rubber grommet (3) over wheel speed sensor connector (L6/3xl, L6/4x1)
4. Disconnect wheel speed sensor connector (L6/3x1,L6/4x1) Installation: Pay attention to correct (L6/3xl,L6/4xl) routing of components.
Installation
5. Install in reverse order, noting the following:
-
Tighten self-locking bolt, rear axle wheel speed sensor to: 8 Nm
-
Pay attention to correct) routing of components.
-
Replace bolts (6a)
-
Lightly lubricate bore in wheel carrier.
-
Check wheel hub rotor for damage.
-
Pay attention to cleanliness of magnetic tip.
-
Secure cables for wheel speed sensors in retaining clips on the tie rod and ensure that they are not damaged when the vehicle suspension moves
towards bump and rebound.