CL 55 AMG (215.374) V8-5.5L SC (113.991) (2004)
9
Remove spring link (6) at wheel carrier (7)
CAUTION: Installation: The rear-axle shaft must be horizontal when tightening the nut
10
Remove link rod torsion bar (6k) from wheel carrier (7)
-
Vehicles with code 489a (AIRMATIC)
11
Press track rod joint (4c) out of wheel carrier (7)
12
Remove thrust arm (5) from wheel carrier (7)
-
Except engine 275
13
Remove tension strut (3) from wheel carrier (7)
-
Except engine 275
14
Remove camber strut (2) from wheel carrier (7)
-
Except engine 275
15
Remove wheel carrier (7) from rear axle shaft (37)
CAUTION: Do not damage rubber boots or rpm sensor rotor.
16
Fasten rear axle shaft (37) with wire
17
Remove rear axle shaft flange (10)
NOTE: Only if brake caliper dust shield (112c) has to be removed.
18
Install in the reverse order
19
Perform chassis alignment check
NOTE: After installation of new parts.