CL 600 (215.376) V12-5.5L Turbo (275.950) (2003)
![background image](/mercedesbenz/cl_600_(215.376)/v12-5.5l_turbo_(275.950)/Page-867001.png)
Engine Control Module: Service and Repair
Removing And Installing The Injection System Control Module
Removing/installing
DANGER:
-
Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate or sliding
roof.
-
When moving components, ensure that no body parts or limbs are within the operating range of moving parts.
1
Open engine hood and raise to vertical position
2
Carry out control module adaptations using STAR DIAGNOSIS
-
Only when replacing the control module ME (N3/10).
3
Unlock cover (1) of the right fuse box (F1/1) and take it off
-
Inspect rubber seal in cover (1), replace if necessary.
4
Disconnect plug connections (2) at ME control module (N3/10)
5
Lift ME control module (N3/10) up and out
6
Install in the reverse order
7
Read out DTC memory