CL 600 (215.378) V12-5.8L (137.970) (2002)
Center Support: Service and Repair
AR41.10-P-0100I Remove/Install Intermediate Bearing and Grooved Ball Bearing
Remove/Install Propeller Shaft Intermediate Bearing and Replacing Grooved Ball Bearing
Remove/Install
1
Remove propeller shaft
2
Separate front propeller shaft with slide connection (1a) from rear propeller shaft (2) at the slide connection
NOTE: Installation: Assemble propeller shaft Coat splined profile with Molykote grease.
3
Pull rubber boot (4) off front propeller shaft
NOTE: Installation: Replace damaged rubber boot (4) and ensure correct fit.
4
Pull off rubber mount (7b) with grooved ball bearing (8)
NOTE: Installation: Press rubber mount (7b) with grooved ball bearing onto linkage arm.
5
Press grooved ball bearing (8) out of rubber mount (7b) of propeller shaft
Inspect
6
Check rubber boot (4), rubber mount (7b) and grooved ball bearing (8) for wear
NOTE: Replace parts if necessary.
7
Install in the reverse order.