CLK 320 (208.365) V6-3.2L (112.940) (1999)
Sunroof / Moonroof Panel: Adjustments
AR77.20-P-1100K Adjusting Sliding/Pop-Up Roof Cover
Removal, Installation
1
Close sliding/pop-up roof cover (1) from sliding position and push lining toward rear
2
Unhook rubber bellows (2) from sliding/pop-up roof cover(1)
3
Remove rail (3) in direction of arrow
CAUTION: First unclip rail at front
Adjustment
4
Loosen screw (5)
5
Insert cardboard strip (6) into sealing joint at rear
NOTE: Cardboard strip (6): 550 mm long and approximately 2 mm thick
6
Adjust sliding/pop-up roof cover (1) in relation to exterior roof surface and tighten screws (5).
Screw for sliding/pop-up roof cover on tilting bracket - 5 N.m
Gap dimension
-
Sliding/pop-up roof cover, front - 0.15 mm
-
Sliding/pop-up roof cover, side and rear - 0.30 mm
Height adjustment
-
Measuring position "A" (x) - 140 mm
-
Front: lower than exterior roof surface - 0-1 mm
-
Rear: higher than exterior roof surface - 0-1 mm
7
Check sliding/pop-up roof for proper function and fit
8
Reinstall in opposite order
NOTE: If wind noises are present: Adjust seal on sliding/pop-up roof cover