CLK 320 (208.365) V6-3.2L (112.940) (1999)
Crankshaft: Service and Repair
Removal and Installation
Remove/install crankshaft
Remove
DANGER:
-
Risk of death. Death may result if vehicle slips or topples from the lifting platform.
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer.
1
Remove engine.
2.1 Detach automatic transmission from engine.
2.2 Detach manual transmission from engine.
3
Detach top part of oil pan.
4
Remove oil pump.
NOTE: Push back chain tensioner for this step and take off chain.
5
Detach belt pulley/vibration damper.
6
Detach flywheel/driven plate.
7
Take off end cover.
8
Take off timing case cover.
9
Remove conrod bearing cap (16).
NOTE:
-
When rotating the crankshaft ensure, that the connecting rod (11) does not tilt.
-
Mark conrod (11) and conrod bearing cap (16) on one side to each other for this step.
10
Unbolt crankshaft bearing caps.
NOTE: Pay attention to slackening diagram.
11
Remove crankshaft bearing caps (4, 10) and fitted bearing (5).