CLK 320 (208.365) V6-3.2L (112.940) (1999)
7
Clean mounting bore for hydraulic mount in wishbone
CAUTION: Do not use any oil, lubricant or grease containing acid.
8
Insert hydraulic mount (4h) in the wishbone from behind (viewed in direction of travel)
NOTE: The parallel surfaces (arrow) of the bearing core must be at an angle of 90 degrees to the center weld seam of the wishbone. In the
installed position when unladen the bearing core is offset towards the center of the vehicle by the dimension "a"
9
Draw in hydraulic mount (4h) up to the stop with thrust washer (012h) part 4 and thrust washer(012e) part 5
NOTE: The straight pins of the thrust washer (012h) part 4 point inwards.
10
Press on washer (4g) flush with bearing core with thrust washer (012e) part 5 and thrust piece (012e) part 3
11
Install lower wishbone (4)