CLK 55 AMG (208.374) V8-5.5L (113.984) (2001)
4
Press suspension-control module lever to position "fill" (F)
CAUTION: Because the pressures are considerable, keep test as brief as possible
NOTE: The rear of the vehicle should rise
-
The suspension-control module's bypass valve limits the supply pressure of the hydraulic pump The bypass valve emits a whistling noise as it
opens If the rear of the vehicle fails to rise within approximately 30 seconds
Model Series 140, 202, 203.2, 208
-
Disconnect return line (T) from reservoir (2), if fluid emerges Replace rear axle level controller
Model 210
-
Checking hydraulic pump If supply rate is within specification, but pressure is too low
-
Replace rear axle level controller
Model Series 140, 202, 203.2, 208
-
If no fluid emerges from the return line, Check hydraulic pump
5
Set level controller lever to" Empty" position (L)
6
Switch off engine
7.1 Connect linkage rod or relay linkage (7) to suspension-control module lever (arrows)
NOTE: Replace self-locking bolts and nuts
7.2 Connect linkage rod for suspension-control module/torsion bar at ball joint
8
Check fluid level in reservoir, correct as indicated