CLK 55 AMG (208.374) V8-5.5L (113.984) (2001)
Tie Rod End: Service and Repair
Removing And Installing Tie Rod Ball Joint
CAUTION: Installation Replace self-locking nuts
1
Press tie rod joint out of steering knuckle m
2
Loosen tapered clamping ring (10f) while holding on hex. shaft
3
Unscrew tie rod end
4
Check joint for play and damaged rubber boot.
-
Replace tie rod ball joint, if necessary
NOTE: The inner joint of the tie rod is permanently connected to the drag link and can therefore only be replaced with the drag link.
5
Install in reverse order
6
Check and adjust toe-in at front axle