CLK 55 AMG (208.374) V8-5.5L (113.984) (2001)
Shown On Model 210
CAUTION: Installation: Replace self-locking nuts
DANGER:
-
Risk of fatal accident from vehicle slipping or toppling off the lift platform
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer.
NOTE: Remove and install rear spring
Adjust roll bar switch
NOTE: Following installation.
6
Spring link
CAUTION: The rear axle shaft must be horizontal when tightening the nuts
6B Rubber bearing to spring link
NOTE: If necessary after checking, Remove/install spring link rubber mount.
6g
Spring link shield
6j
Remove shock absorber or spring strut at spring link
6k
Torsion bar link rod
6i
Remove/install guide rail at spring link
36
Frame cross-strut
118B Linkage between headlight leveling device and right-hand spring link
-
Vehicles with xenon headlamps only
S83/2, S83/3 Remove/install left or right rear axle roll bar (RB) switch