CLK 55 AMG (208.374) V8-5.5L (113.984) (2001)
Drive/Propeller Shaft: Testing and Inspection
AR41.10-P-0085-02P Measure Absolute Angle at Front and Rear Propeller Shafts
AR41.10-P-0085-02P Measure absolute angle at front and rear propeller shafts
The vehicle must be on its wheels for the measurement.
All four angles should be measured in succession without interruption.
An angle that has already been measured can be measured a second time if required. To do this, with the Measurement menu displayed, press the
STEP button repeatedly until the display indicates ready to measure the relevant angle.
Component Identification
Measurement - Angle 2: front propeller shaft
1
Clean contact surfaces for sensor (020a) on front propeller shaft (1).
2
Position sensor (020a) horizontally on front propeller shaft (1) and press on firmly.
The spiral cable (020b) of the sensor (020a) must point in the direction of travel for each measurement. Otherwise the measurement will be
inaccurate.
If the sensor (020a) is not positioned horizontally on the front propeller shaft (1), the error message "Y-positional error - sensor ??" appears on the
display. The measured angle cannot be saved.
Shown on model 203, 209
Component Identification
Show on model 230