E 300 (124.131) L6-3.0L DSL (606.910) (1995)
Camshaft: Procedures
NOTE: Numbers in parentheses ( ) indicate a component or tool in the associated illustration.
REMOVAL
1. Remove camshafts (6, 7), refer to Camshaft Replacement.
2. Use a suitable screwdriver to pry out end cover.
-
Do not damage basic bore of camshaft.
3. Clean mounting hole for metal cover of hollow-drilled camshaft, remove grease
INSTALLATION
-
Use a locally made drift to knock in end cover (1), refer to Tools and Equipment.
Use new end cover (1)
The end cover (1) must not be seated at the end of the bore; pay attention to insertion depth.
-
Install camshafts (6, 7)