E 300 (124.131) L6-3.0L DSL (606.910) (1995)
INSTALLATION
-
Install in the reverse order, noting the following:
Inspect hub at belt pulley/vibration damper (1c) for grooves caused by wear
If a groove resulting from the radial seal can be felt, replace front crankshaft radial seal and install in repair position. See: Seals and
Gaskets/Front Crankshaft Seal/Service and Repair
Align parallel key (8); fix in place with grease if necessary. Turn to ensure that the groove is aligned with the parallel key in the crankshaft.
Tighten central bolt of pulley/vibration damper (1c) in two stages to:
1st stage: 200 Nm
2nd stage: turn 90°