E 320 4MATIC Sedan (211.082) V6-3.2L (112.954) (2004)
Suspension Spring ( Coil / Leaf ): Removal and Replacement
AR32.20-P-0230P Remove/Install Rear Spring
AR32.20-P-0230P Remove/Install Rear Spring
- except CODE (P98) Black Series [model 209]
- except CODE (489) Airmatic [models 211.0, 219]
Shown On Model 203
DANGER:
-
Lethal injuries are possible if vehicle slips off of lifting platform
-
Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by
the vehicle manufacturer.
CAUTION: See notes on self-locking nuts and bolts
1
Remove cover (72c) of spring link (72).
2
Insert clamping plates (01b, 01c) in rear spring (73).
3
Insert spring compressor (01a) in clamping plates (01b, 01c).
DANGER:
-
Risk of injury from jamming or bruises when working on springs or spring bosses which are tensioned
-
Use only approved tensioning devices; additionally shield off hazardous area if necessary.
-
Inspect special tools for damage and proper operation (visual inspection)
-
Wear protective gloves.
4
Tension rear spring (73)
NOTE: Installation:
-
Model 203: On undamped springs the clamping plates should be fitted so as to leave approx. two coils free at the ends of the spring.
-
Model 211: Observe chalk markings.
NOTE: Springs; general background information.
5.1 Unscrew nut (72b) and detach spring link (72) from rear axle carrier.