E 320 4MATIC Wagon (210.282) V6-3.2L (112.941) (1998)
Component Identification
14
Check riveting (arrows), re-rivet if necessary.
15
Fit on camshaft sprocket (6).
Pay attention to tightening torque of camshaft sprocket.
The colored markings (8) on the timing chain and at the camshaft sprocket must be aligned.
AR05.10-P-7601-04AV Drawing In Timing Chain
AR05.10-P-7601-04AV Drawing in timing chain
Special Tools
Component Identification
1
Connect the new timing chain (1) and the old timing chain (2) with the assembly link (3) (arrow).
Do not use an assembly plate and an assembly retainer. While drawing in the new timing chain (1), the assembly retainer can get jammed and jump
off at the slide rails.
2
Slowly rotate crankshaft in direction of rotation of engine until the ends of the new timing chain (1) can be connected.
Always keep new timing chain (1) meshed with the camshaft sprocket. Pull out the free end of the timing chain (4) steadily corresponding with the
drawing in of the new timing chain (1).
3
Remove the assembly link (3) and place the old timing chain (2) to the side.