E 320 4MATIC Wagon (210.282) V6-3.2L (112.941) (1998)
Camshaft Position Sensor: Adjustments
CHECKING, ADJUSTING CLEARANCE OF CAMSHAFT POSITION SENSOR CAMSHAFT SPROCKET SEGMENT
Adjusting
1. Position crankshaft to 25° CKA before ignition TDC of cylinder 1.
Measuring
2. Use a depth slide gauge to measure size "A" from the plane face of the camshaft position sensor (L5/1) at the cylinder head to the segment (arrow)
on the camshaft sprocket.
NOTE: Enter size "A" in table (see calculation example below).
Calculation Examples
3. Use depth slide gauge to measure size "B" at camshaft position sensor (L5/1) without shim from the contact surface to the position sensor.
NOTE: Enter size "B" in table (see calculation example).