E 320 4MATIC Wagon (210.282) V6-3.2L (112.941) (1998)
Fuse Block: Service and Repair
Remove/Install Fuse and Relay Box
Removal, installation
1
Disconnect ground lead from battery
CAUTION: Insulate cable terminal on ground lead for protection against unintentional contact between disconnected ground lead and
ground connection point W10
2
Remove cover (1)
NOTE: Ensure that gasket is not damaged
3
Unscrew screws (2) and remove cover (3) on fuse and relay box (F1)
NOTE: Ensure that gasket is not damaged
4
Unscrew screw (4) for data link connector (X11/4)
5
Unclip fuse blocks (A-F) from carrier (5)
6
Remove carrier (5) from fuse and relay box (F1)
NOTE: To do this guide fuse blocks downward out of carrier
7
Separate connector field on data link connector (X11/4)
NOTE: For this purpose unhook from bottom in middle of connector field and remove loose half of connector field
8
Disconnect leads with coded plugs on fuse blocks