E 320 4MATIC Wagon (211.282) V6-3.2L (112.954) (2003)
Body Control Module: Service and Repair
AR54.21-P-1258TA Remove/Install Sam With Fuse and Relay Box, Rear
AR54.21-P-1258TA Remove/Install Sam With Fuse and Relay Box, Rear
Shown On Vehicle With Code (890), Automatic Rear-end Door
1
Connect STAR DIAGNOSIS and stage basic data from rear SAM control module with fuse and relay module (N10/2) in STAR DIAGNOSIS
NOTE
-
Only when installing new rear SAM control module with fuse and relay module (N10/2)
-
Installation: Transfer staged basic data to new rear SAM control module with fuse and relay module (N10/2)
-
Diagnosis system STAR DIAGNOSIS
2
Disconnect ground cable of battery
3
Remove left side inner paneling of load compartment (1)
4
Remove left side paneling in rear
5
Remove hazard warning triangle
6
Unscrew bolt (6), remove equipment carrier (7) and place to one side
7
Remove wiring harness (8) from bracket (9) and place to one side
NOTE: Installation, replace tie straps
8
Unscrew nuts (10) and bolt (11)
9
Unscrew nuts (12) and place hydraulic pump housing (13) to one side
10
Unplug electrical connectors from rear SAM control module with fuse and relay module (N10/2) and remove rear SAM control module with fuse
and relay module (N10/2) from load compartment
NOTE: Number of electrical connectors depends on equipment configuration.
11
Install in the reverse order