E 320 4MATIC Wagon (211.282) V6-3.2L (112.954) (2003)
Rear Subframe: Procedures
AR35.10-P-0055-04T Check bolted connection
Modification Notes
Rear Axle Carrier
1
Set torque wrench to 100 Nm.
2
Apply set torque to bolt (in release direction).
^
If the torque wrench cracks, then the bolted connection is OK and the test over.
^
If the bolt is released, then the bolted connection is not OK Proceed with step 3.
3
Unscrew bolt and replace bolt.
4
Clean thread of bolt in frame floor assembly.
5
Tighten new bolt according to tightening instructions (see table above).
6
Set torque wrench to 130 Nm.
7
Apply set torque to bolt (in tighten direction).
^
If the torque wrench cracks, then the actual torque (>=130 Nm) has been reached, the bolted connection is OK and the test over.
^
If the bolt turns, then the actual torque (<=130 Nm) has not been reached and the bolted connection is not OK Proceed with step 8.
8
In this case, the base plate must be inspected for cracks using an endoscope