E 320 4MATIC Wagon (211.282) V6-3.2L (112.954) (2003)
-
Installation: Pay attention to color coding of fuse holder (11).
16
Unscrew nuts (12)
17
Unscrew nut (13) and remove front prefuse box (F32)
-
Nut, terminal 30 in prefuse box: 7 N.m
18
Install in the reverse order.
AR54.15-P-1340T Remove/Install Rear Prefuse Box
AR54.15-P-1340T Remove/Install Rear Prefuse Box
1
Remove trim panel of rear center section
2
Disconnect ground cable of battery
3.1 Lift TIREFIT box out of spare wheel recess
3.2 Remove spare wheel from spare wheel recess
4
Unscrew screws (4) from tool box (3) unclip tool box (3) using mounting wedge (5) and then remove
See "Special Tools" given below.
5
Remove clips (2) and raise spare wheel recess trim panel (1) until rear prefuse box (F33)can be accessed
NOTE:
-
Remove all clips (2) from spare wheel recess trim panel (1). Number of clips (2) vanes depending on equipment configuration.
-
Support spare wheel recess trim panel (1) using a suitable object
-
Installation: Install new clips (2)
See "Commercially Available Tools" given below.
6
Mark installation position of individual supply lines (red) (6)
NOTE: Number of supply lines (red) (6) varies depending on equipment configuration.
7
Slacken nuts securing supply lines (red) (6) to rear prefuse box (F33) and move supply lines (red) (6) to one side
NOTE:
-
Nuts remain attached to supply lines (red) (6).
-
Installation: Observe markings showing installation position
-
Nut securing supply lines to rear prefuse box: 7 N.m