E 320 4MATIC Wagon (211.282) V6-3.2L (112.954) (2003)
NOTE:
-
This does not apply to vehicles with different tires of varying specifications on the front and rear wheels.
-
Depending on the extent of wear after a distance of between 5,000 and 10,000 km.
9
Push on wheels and tighten wheel bolts
-
All except model 210 with special protection version code (979)
10
Lower the vehicle, correct tire pressure of all wheels and fit wheel covers
NOTE:
-
If there is a loss of tire pressure: determine cause and replace the tire if necessary.
-
On vehicles with tire pressure monitor code (475): Only use plastic valve caps (risk of corrosion).
11
Fit wheel covers
12.1 Correct tire pressure of spare wheel
-
Vehicles with spare wheel
NOTE:
-
If there is a loss of tire pressure: determine cause and replace the tire if necessary.
-
On vehicles with tire pressure monitor code (475)
-
Only use plastic valve caps (risk of corrosion).
12.2 Check expiry date of TIREFIT tire sealant TIREFIT tire sealant
-
Vehicles with TIREFIT
13
Activate tire pressure monitor
-
On vehicles with tire pressure monitor code (475), Only when replacing a wheel, changing tires or altering the tire pressure.
AZ40.10-P-0001-03A Removing Standard Wheels
AZ40.10-P-0001-03A Removing standard wheels
1
Loosen wheel bolts
2
Lift vehicle
3
Unscrew wheel bolts
When unscrewing the last wheel bolt, ensure that the wheel does not tilt off the hub in an uncontrolled manner.
4
Remove wheel
For driving with the spare wheel, refer to the Owner's Manual.
AH40.10-P-0008-01TB Notes on Conversion to 17- or 18-Inch Tires
AH40.10-P-0008-01TB Notes on conversion to 17- or 18-inch tires
Technical information
On all vehicles without:
^
Code 950 EVOLUTION AMG sport package
^
Code 952 Sport package
^
Code 486 MB sports suspension
^
Code 489 All-round level control system
^
Code 954 Avant-garde as of model refinement package 06.2006 for a conversion to 17 or 18 inch tires new stop rubbers must be fitted as jounce
limitation.
Legal provisions
Before a conversion to 17 or 18 inch tires the following must be available:
^
a corresponding expert's report on the parts (Federal Republic of Germany)
^
national legislation must be taken into account (except Federal Republic of Germany).
Technical measures
^
With standard suspension
^
With code 485 Standard suspension instead of Avant-garde suspension
^
With code 494 California version