E 320 4MATIC Wagon (211.282) V6-3.2L (112.954) (2003)
Seals and Gaskets: Service and Repair
AR33.30-P-0530P Replace Radial Sealing Ring on Front Axle Drive Pinion
Replace Radial Sealing Ring On Drive Pinion
Illustration Shows Front Axle Gear For Model 203
DANGER:
-
Lethal injuries are possible if vehicle slips off of lifting platform
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer
1
Raise vehicle
2
Detach lower engine compartment paneling
3
Remove front axle gear propeller shaft
4
Remove exhaust shielding plate for front axle gear propeller shaft
5
Remove drive pinion with bearing cap (47)
NOTE: Mark bearing cap in relation to housing of front axle gear Collect any universal hypoid gear oil which flows out
6
Remove spacer washer (47a)
NOTE: Installation: Inspect spacer washer, install new part if necessary, pay attention to thickness.
7
Take off O-ring (47b)
NOTE: Installation: Install new O-ring and coat circumference with universal hypoid gear oil
8
Replace radial sealing ring (42)
NOTE: Coat sealing lip of radial sealing ring with universal hypoid gear oil
9
Install in the reverse order
10
Checking front axle gear oil level and topping up if necessary
AR33.30-P-0540VM Install New Radial Sealing Ring on Outside Right of Front Axle Gear
AR33.30-P-0540VM Install New Radial Sealing Ring on Outside Right of Front Axle Gear