mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Campaign - ECM/TCM Software Updates|Page 1372 > < Campaign - ECM/TCM Software Updates
Page 2
background image

-

Follow the DAS path "Version coding" and on-screen instructions.

4. Vehicles with engine M273 only: Install and code engine control module software.

-

Install: Follow the DAS path "Control unit adaptations/ Control unit programming" and on-screen instructions.

-

SCN coding: Follow the DAS path "Version coding" and on-screen instructions.

NOTE:  SCN coding must be performed even if the "No newer control module software was found" message appears when attempting to flash the
engine control module.

5. Erase all fault codes and event memory.
6. All vehicles except Models 164.122 and 164.822 up to, and including, VIN A067677: Perform transmission adaptation up to fourth gear.

-

Follow the DAS path "Adaptations" and on-screen instructions.

-

Select transmission mode "S".

-

Select adaptation 1-2 gear in DAS; enter first gear manually and accelerate vehicle slightly, then manually up-shift according to on-screen
instructions; repeat scenario for adaptations 2-3 and 3-4.

NOTE:  

Let vehicle coast down after each shift.

-

Perform the adaptations 1-2, 2-3, and 3-4 gear twice.

7. Disconnect Star Diagnosis.

NOTE:  The following allowable labor operation should be used when submitting a warranty claim for this repair:

Warranty Information

Repair 1 (Check transmission control module software)

Operation: Star Diagnosis System (SDS), Connect & Disconnect (02-4762)

Battery Charger, Connect (with SDS connected) (02-5058)
Transmission Control Unit Software, Check (with SDS connected) (02-5523)

Repair 2 (Install transmission control module software)

Operation: Star Diagnosis System (SDS), Connect & Disconnect (02-4762)

Battery Charger, Connect (with SDS connected) (02-5058)
Transmission Control Unit Software, Check (with SDS connected) (02-5523)
Transmission Control Unit Software, Install (with SDS connected) (02-5524)
Control Unit (with SDS connected), Code (02-5382) Adaptation, Perform (after Repairs) (27-1047)

Repair 3 (Install transmission control module SW; check engine control module SW)

Campaign - ECM/TCM Software Updates|Page 1372 > < Campaign - ECM/TCM Software Updates