E 320 Coupe (124.052) L6-3.2L (104.992) (1994)
Muffler: Service and Repair
Replacing Center And Rear Muffler
Shown On Model 124 Sedan, Part 1
Shown On Model 124 Sedan, Part 2
DANGER:
-
Risk of explosion from ignition. Risk of poisoning from inhaling and swallowing fuel. Risk of injury as a result of fuel coming into contact
with skin and eyes.
-
No fire, naked flame or smoking.
-
Pour fuels only into suitable and appropriately marked containers.
-
Wear protective clothing when handling fuel.
1
Remove exhaust system from flange connection
NOTE: Installation: Model 202.028 E 36 AMG: pay attention to installation position and suspension of rear muffler.
2
Place new rear muffler (9a) with plug connection exactly over the removed exhaust system and mark length of pipe of new rear muffler on the
removed exhaust system
3
Cut through the pipe 80 mm from the marking (tolerance minus 10 mm) in direction of rear muffler so as to ensure an insertion depth of 70 - 80
mm
-
If center muffler faulty, the center and rear muffler unit must be replaced complete
4
Install in reverse sequence
-
Use exhaust pipe clamp (7/2)
NOTE: When attaching the exhaust system, ensure that the projection "a" of the bracket at the rear muffler is not more than 3 - 5 mm at the
rubber mount (18) (see fig.) when exhaust is cold.