E 320 Sedan (210.065) V6-3.2L (112.941) (1999)
Component Identification
The multifunction control module (N10-1) contains the following previously separate control modules
-
Convenience control module (N57)
-
Convenience relays (K24)
-
Wiper system relays (K26, K26k1, K26k2, K26k3)
-
Time function relay (K13)
It controls the following functions
-
4 power windows
-
Outside mirror adjustment (only with driver memory)
-
Tilting/sliding roof
-
Interior lighting
-
Exit lamps
-
Central locking interior actuation switch (switch signal only)
-
Turn signals
-
Jacket tube memory
-
Rear window defroster (switch signal only)
-
Wiper system control
-
Rear head restraints (switch signal only)
-
Residual heat (switch signal only)
-
Trunk lid remote control (switch signal only)
The multifunction control module (N10-1) can be coded for specific countries and specific models.
New control modules connected to battery voltage for the first time, must be programmed with the following data using the HHT:
The multifunction control module (N10-1) can be reprogrammed as often as desired, e.g. when equipment is retrofitted.
Coding
-
(USA)/ECE
-
(CH)
-
Right-hand steering/left-hand steering
-
Model 210.0 (sedan)
Model 210.2 (T-model)
Coding equipment
-
ATA (including interior lighting with ATA alarm on/off)
-
Driver's seat with memory
-
Passenger seat with memory
-
Rain sensor
NOTE: On vehicles with left front seat memory each switching position for the outside rear view mirror as well as for the steering column must be
actuated for >= 2 sec. with the appropriate control switch with the ignition ON after replacing the multifunction control module (N10-1) or interrupting
the power.
Fault memory
The fault memory for the multifunction pneumatic system equipment (A37) is integrated into the multifunction control module (N10-1).