E 320 Wagon (124.092) L6-3.2L (104.992) (1994)
/l6-3.2l_(104.992)/Page-1645001.png)
Alignment: Service and Repair
Front Wheel Alignment
Preliminary Check
Preliminary Check
On models equipped with electronic level controls, ensure proper system operation prior to adjusting wheel alignment.
Front Camber & Caster
Front axle provides for combined camber and caster adjustment. Both wheel adjustments can be made together. Adjustments are made by means of
eccentric bolts at lower control arm bearing and brake support ball pin supporting joint.
To adjust eccentric bolt on lower control arm bearing, loosen hex nut, then tighten hex nut while applying counter hold to eccentric bolt.
When increasing camber on eccentric bolt, caster will also increase. When decreasing camber, caster will also decrease.
To adjust supporting joint ball pin, loosen clamp and turn ball pin in supporting tube (ball pin is righthand threaded). Turning outward will
increase caster, turning inward will decrease caster. When increasing caster, camber will decrease, when decreasing caster, camber will increase.
