E 320 Wagon (211.265) V6-3.2L (112.949) (2003)
-
Model 211.004/006/206/016/216/026/226/042/242/043/243/061/261/065/265
4.2.1 Separate heat shields (105d, 105e) and detach from body
-
Model 211.028/070/270/076/276
4.2.2 Remove both halves of heat shield (105e)
-
Model 211.028/070/270/076/276
5
Detach retracting spring (94) from bridge (70)
NOTE: Installation: After installing retracting spring (94), slacken automatic cable slack adjuster (92)
6
Unhook front brake cable (85) from automatic cable slack adjuster (92)
7
Pre-tension automatic slack adjuster (92)
8
Unhook rear brake cable (86) from automatic cable slack adjuster (92)
9
Unclip rear brake cable (86) from bridge (70) using snap-release tool (042)
10
Pull rear brake cable (86) out of front center assembly suspension (51)
CAUTION: While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any
scratches, cracks and notches. Otherwise the service life of the parts will be reduced.
NOTE: Lever grommet (86a) out of front center assembly suspension (51).
11
Remove parking brake shoes
12
Pull rear brake cable (86) out of wheel carrier (7)
13
Press retaining collar (86b) together and pull downwards out of bracket (86c) with rear brake cable (86)
14
Install in the reverse order
Inspect
15
Check version of pedal assembly
16
Adjust parking brake
17
Activate SBC brake system using STAR DIAGNOSIS.
18
Use STAR DIAGNOSIS to move brake pads toward brake disks