E 320 Wagon (211.265) V6-3.2L (112.949) (2003)
Measurement Point 1 (Right Front) Illustrated
Measurement Point 3 (Left Rear) Illustrated
1
Prepare for chassis alignment check
2
Check vehicle level at the front axle via the spring link inclination
-
Clean measurement points on spring link (17)
CAUTION: The connecting cable (086b) for the sensor must point towards the center of the vehicle otherwise the measurement will be
incorrect.
-
Position test sensor (086a) on track control arm (17) between the cast supports (arrows) and store each of the test results.
-
Measurement point 1 (left front)
-
Measurement point 2 (right front)
NOTE: Vehicle with metal springs: If the front ride height is outside of specification. Replace the springs or the rubber spring bushings to adjust
the vehicle ride height.
3
Check vehicle level at the rear axle via the rear axle shaft inclination.
-
Clean measurement points on rear axle shaft (65).
CAUTION: The connecting cable (086b) for the sensor must point towards the center of the vehicle otherwise the measurement will be
incorrect.
-
Fit measurement sensor (086a) on rear axle shaft (65) and save each measured value.
-
Measurement point 3 (left rear)
-
Measurement point 4 (right rear)
NOTE:
-
Vehicle with metal springs: If the rear ride height is outside of specification, Replace the springs or the rubber spring bushings to adjust the
vehicle ride height.
-
Observe specified maximum tilt-angle variation between left and right sides of vehicle
-
The specified test tolerance applies only when checking the vehicle level and not for calibration.
4
Use STAR DIAGNOSIS to calibrate vehicle ride height