E 350 4MATIC Sedan (211.087) V6-3.5L (272.972) (2006)
Relay Box: Service and Repair
AR54.21-P-1260T Remove/Install Sam With Fuse and Relay Box, Left Front
AR54.21-P-1260T Remove/Install Sam With Fuse and Relay Box, Left Front
1
Connect STAR DIAGNOSIS and store basic data from driver-side SAM control module with fuse and relay module (N10/1) temporarily in STAR
DIAGNOSIS
-
When replacing the driver-side SAM control module with fuse and relay module (N10/1)
NOTE:
-
Installation: Transfer basic data stored on an interim basis to the new driver-side SAM control module with fuse and relay module (N10/1)
-
Diagnosis system STAR DIAGNOSIS
2
Disconnect ground cable of battery
3
Open hood and raise to vertical position
4
Disengage lever (10) in direction of arrow and remove cover (2) from fuse and relay box (3)
5
Separate electrical connectors (4)
6
Detach electric cable (5) from driver-side SAM control module with fuse and relay module (N10/1)
7
Unscrew screws (6) and remove the driver-side SAM control module with fuse and relay module (N10/1) from the fuse and relay box (3)
NOTE:
-
Until the electrical connectors under the driver-side SAM control module with fuse and relay module (N10/1) are accessible
-
Installation: Pay attention to line routing Hooks (7) must latch in place
8
Unplug all electrical connectors from driver-side SAM control module with fuse and relay module (N10/1)
NOTE: Installation: observe color codings
9
Unclip relay (8) with bracket from driver-side SAM control module with fuse and relay module (N10/1).
10
Remove driver-side SAM control module with fuse and relay module (N10/1)
11
Install in the reverse order
12
Read out DTC memory