E 350 4MATIC Sedan (211.087) V6-3.5L (272.972) (2006)
/v6-3.5l_(272.972)/Page-5099019.png)
6. Clean working area with wet/dry vacuum cleaner. Wet and dry vacuum cleaner.
AH67.10-P-1000-01P Notes on Removal/Installation of Windshield
AH67.10-P-1000-01P Notes On Removal/Installation Of Windshield
^
Allow primer to air dry for 10 min. to avoid negative effects to the adhesive action of the glue.
^
The crank window in the driver door must be opened during the curing time to prevent the windshield from being pressed out by the air when the
doors are closed.
^
Install windshield on body flange within 10 minutes before adhesive force of glue starts to decrease.
^
Drive-away time for 2-component repair kit is 1 h.
^
Drive-away time for 1-component repair kit is 2 h.
^
The gluing area on the body flange must be absolutely free of dust and grease to prevent a decrease in the gluing force when installing window.
AR67.10-P-1000-01TS Cut Windshield Out With Cutting Blade
AR67.10-P-1000-01TS Cut Windshield Out With Cutting Blade
- with CODE (Z04) Light armoring
1. Tape surface zones on windshield cutout on front edge of roof and left and right A-pillar with adhesive tape (2).
Attach adhesive tape (2) to prevent paint damage.
2. Remove apex seal on windshield (1) at top to front edge of roof with suitable tool
3. Cut adhesive bead and support bead on windshield (1) with window removal tool (area B).
Window removal tool, see GOTIS
http://gotis.aftersales.mercedes-benz.com
Cutting blade, L-shape, cutting length 25.4 mm
Order no.:6 39 03 207 01 2, www.fein.com
4. Cut through adhesive seam on windshield (1) in connection areas on left and right A-pillar and front edge of roof with window removal unit (area
A).
Window removal tool, see GOTIS
http://gotis.aftersales.mercedes-benz.com
Cutting blade, L-shape, cutting length 19 mm
Order no.:6 39 03 208 01 0, www.fein.com
To prevent damaging the lower area of the A-pillar, interrupt cutting procedure, remove cutting blade from window removal tool, turn window
removal tool 180° and reclamp cutting blade. Then continue cutting operation.
