E 350 Sedan (212.056) V6-3.5L (272.980) (2010)
/v6-3.5l_(272.980)/Page-2589002.png)
4. Loosen protective foil on adhesive strips on rear mud guards (2) from corners and position so that ends of protective foil extend beyond outer edge
of rear mud guards (2).
Do not remove protective foil on adhesive strips completely.
5. Position rear mud guard (2) on rear bumper as shown in figure.
6. Screw sheet metal screws (4) into fender liner.
7. Screw in self-tapping sheet metal screw (7)
On vehicles with single-pipe exhaust system, install the previously removed expansion rivet on the right side of the vehicle instead of the
self-tapping sheet metal screw (7).
8. Position rear mud guards (2) on rear fender as shown in figure and fasten with clips (8).
A barb (8.1) is present on the clips (8) for the rear mud guards (2) on both sides.
9. Screw sheet metal screw (3) into rear bumper.
10. Remove entire protective foil from adhesive strips on rear mud guards (2) and uniformly press adhesive strips against rear bumper (2).
