E 500 (211.070) V8-5.0L (113.967) (2004)
20
Disconnect filler hose (17) of fuel tank from filler neck (17a)
CAUTION: Collect escaping fuel in a suitable container!
-
Check filler hose and hose clamps, if necessary empty fuel tank and replace filler hose.
21
Lower rear axle
22
Mark installation position of torque strut (3) on rear axle carrier (1) and on torque strut (3) with felt pen
CAUTION: Do not mark by scratching or notching the surface!
23
Detach torque strut (3) from rear axle carrier (1)and remove
NOTE: Installation: Transfer installation position marking to new torque strut and bolt torque strut to rear axle carrier (1) in the correct
position.
24
Replace retaining clips for air springs
-
With Airmatic, code (489a)
25
Install in the reverse order
26
Activate SBC brake system using STAR DIAGNOSIS
27
Use STAR DIAGNOSIS to move brake pads toward brake discs
28
Carry out chassis alignment check.