E 500 4MATIC Wagon (211.283) V8-5.0L (113.969) (2004)
Pump: Service and Repair
Removing And Installing Pneumatic Pump For Dynamic Seat Control
1
Disconnect ground cable of battery
2
Remove left side Inner paneling of load compartment
3
Remove hazard warning triangle (1)
4
Loosen sound-deadening material (2) in the lower area and fold upwards
NOTE: Installation: Pay attention to correct seating of sound-deadening material (2).
5
Remove pneumatic pump for dynamic seat control (M40/1) with the sound-deadening materials (3) upwards out of the bracket (4)
6
Remove sound-deadening materials (3) from the pneumatic pump for dynamic seat control (M40/1)
7
Detach pneumatic connections (5) from the pneumatic pump for dynamic seat control (M40/1)
8
Disconnect electrical connector (6) and remove the pneumatic pump for dynamic seat control (M40/1) from the load compartment
9
Install in the reverse order