E 55 AMG Wagon (211.276) V8-5.5L SC (113.990) (2006)
Headlamp Bulb: Service and Repair
AR82.10-P-1201T Remove/Install Bulbs of Headlamp Unit
AR82.10-P-1201T Remove/Install Bulbs of Headlamp Unit
- Low beam bulb
- with CODE (614) Bi-Xenon headlamp
- with CODE (615) Bi-Xenon headlamp unit with integrated cornering lamps
DANGER:
-
Danger from Xenon headlamp high voltage
-
Do not touch parts which conduct high voltages. Persons with active electronic implants (e.g.heart pacemakers) should never work on
xenon headlamps.
1
Disconnect ground cable of battery
2
Remove cover (5) on xenon headlamp
3
Rotate and remove Xenon headlamp ignition module (E1n2, E2n2) on Xenon headlamp
NOTE: Do not break off latching lugs. Electrical connector (4) is automatically unplugged.
4
Turn and remove retaining collar (2)
NOTE: Do not break off latching lugs.
5
Remove gas discharge lamp (1)
NOTE: Do not touch the gas discharge lamp (1) with your bare fingers but use a grease-free, soft cloth
6
Check power supply contact points for corrosion
NOTE: If necessary, replace corroded part.
7
Insert gas discharge lamp(1) into Xenon headlamp and hold in place
-
Ensure that they are installed in the correct position (notch).
NOTE: Do not touch the gas discharge lamp (1) with your bare fingers but use a grease-free, soft cloth
8
Put on retaining collar (2) and rotate
NOTE: Note inscription "Top" on the retaining collar (2).
9
Mount Xenon headlamp ignition module (E1n2, E2n2) and rotate
NOTE: Installation position must be noted.
10
Connect electrical connector (4)
11
Fit cover (5) to Xenon headlamp
NOTE: Check seal in cover (5) for signs of damage and wear, if necessary fit a new seal to the cover (5).
12
Reconnect ground lead to battery