mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

AR40.20-P-0230I Attaching Mercedes-Benz Rapid-Clamping Devices|Page 3507 > < AR40.20-P-0230I Attaching Mercedes-Benz Rapid-Clamping Devices|Page 3505
Page 11
background image

-

Vehicles with AIRMATIC DC.

NOTE:
-

Only if the vehicle level is outside the test tolerance.

-

Possible causes and remedies when the vehicle level is not OK after calibration:
-

Mount for level sensor is bent out of shape

5

Check and correct headlamp adjustment
-

Only if the vehicle level was adjusted.

AR40.20-P-0325I Check Toe-Out on Turns

Checking Toe-out On Turns

1

Check and adjust front axle toe

2

Check toe-out on turns

NOTE:
-

The toe-out on turns is measured to check the steering geometry. This is the difference in the steer angle between the outside wheel and the
inside wheel when the inside wheel is steered through 20 degrees.

-

If substantial deviations are found, the cause may be one of the following, assuming that the camber and caster settings are correct:
-

Toe not adjusted with the rack-and-pinion steering in the straight-ahead position, resulting in tie rods of unequal length.

-

Steering knuckle or tie rod bent.

-

On vehicles involved in an accident, excessive deviations in the front end (frame side members, frame crossmembers, wheel housings and
firewall or on the front axle carrier) with detrimental effects on the camber and caster adjustment ranges, resulting in large differences in
the toe-out on turns between the left and right sides.

AR40.20-P-0331T Check and Adjust Rear Axle Camber/Caster

Checking Rear Axle Camber

1

Check vehicle level at front and rear axles with electronic clinometer

2

Check rear axle camber

NOTE:
-

The camber on the rear axle is not adjustable.

-

If substantial deviations in the rear axle camber are found, the cause may be one of the following:
-

Excessive difference in the vehicle level between the left and right sides of the vehicle.

-

Accident damage to the frame floor. Level differences at the mounting points for the rear axle carrier between the left and right sides of the
body. Experience shows that bending caused by an accident also has an effect on the toe.

AR40.30-P-0400P Checking accident vehicles and vehicles possibly damaged in an accident

AR40.30-P-0400P Checking accident vehicles and vehicles possibly damaged in an accident

- except CODE (P98) Black Series [model 209.3]

AR40.20-P-0230I Attaching Mercedes-Benz Rapid-Clamping Devices|Page 3507 > < AR40.20-P-0230I Attaching Mercedes-Benz Rapid-Clamping Devices|Page 3505