mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

AR54.65-P-0001T Remove/Install Parktronic System (PTS) Sensors In Front Bumper|Page 1535 > < AR54.65-P-0001T Remove/Install Parktronic System (PTS) Sensors In Front Bumper|Page 1533
Page 9
background image

4. Insert warning tone speaker into opening in left rear shelf reinforcement and fix with double-sided adhesive tape under the opening for the cover

retaining lug.

Bonding surfaces must be pre-treated in accordance with adhesive tape manufacturer's instructions.

5. Connect warning tone speaker branch-off line (17) to warning tone volume "Medium".
6. Fix warning tone speaker branch-off line (17).

Depending on the fitting point or customer request the warning tone volume can be switched over to "Loud" or "Quiet".

7. Route sensor wiring harness (5) to bumper reinforcement and fasten with cable ties so that it cannot chafe or make noises.
8. Connect couplings with rubber seals of sensor wiring harness (5) to sensors (3).

The rubber seals must be installed over the sensor connectors so that the connections are watertight.

9. Remove rubber plug from the opening in the trunk floor.

10. Route sensors wiring harness (5) in through the opening and seal opening with the grommet (12) attached to the sensors wiring harness.

AR54.65-P-0001T Remove/Install Parktronic System (PTS) Sensors In Front Bumper|Page 1535 > < AR54.65-P-0001T Remove/Install Parktronic System (PTS) Sensors In Front Bumper|Page 1533