E 55 AMG Wagon (211.276) V8-5.5L SC (113.990) (2006)
CAUTION: Installation: Tighten bolted connections of torque strut, camber strut, thrust arm and track rod.
11
Detach torque strut (3) from wheel carrier (7)
CAUTION: Installation: Secure torque strut loosely.
12
Detach camber strut (2) from wheel carrier (7)
CAUTION: Installation: Secure camber strut loosely
13
Detach tie rod (4) from wheel carrier (7)
CAUTION: Installation: Secure track rod loosely.
14
Detach thrust arm (5) from wheel carrier (7)
CAUTION: Installation: Secure thrust arm loosely.
15
Lower transmission jack
NOTE: Installation: Raise wheel carrier (7) with transmission jack and transmission platform until axle shaft (37) is roughly horizontal.
16
Fold wheel carrier (7) back and pull rear axle shaft (37) out of wheel bearing (10)
CAUTION: Hook the rear axle shaft up to avoid damaging the rubber sleeve of the rear axle shaft.
-
If the rear axle shaft is difficult to remove, Press rear axle shaft out of rear axle shaft flange
17
Undo bolts (10a) and pull wheel bearing (10) out of wheel carrier (7)
18
Install in the reverse order
19
Adjusting parking brake
20
Activate SBC brake system using STAR DIAGNOSIS.
21
Use STAR DIAGNOSIS to move brake pads toward brake disks
22
Carry out chassis alignment check.
AR35.20-P-0302TA Remove/Install Wheel Bearing
AR35.20-P-0302TA Removing/installing wheel bearing
- except CODE (489) Airmatic (semi-active air suspension)