E 55 AMG Wagon (211.276) V8-5.5L SC (113.990) (2006)
Center Support: Removal and Replacement
AR41.10-P-0100T Remove/Install Intermediate Bearing and Grooved Ball Bearing
AR41.10-P-0100T Remove/Install Intermediate Bearing and Grooved Ball Bearing
Remove/Install
1
Remove propeller shaft
2
Separate front and rear half of propeller shaft (1, 2) at the sliding connection
CAUTION: Installation: Coat splined shaft profile with Molykote grease.
3
Detach boot (4) from front half of propeller shaft (1)
CAUTION: Installation: Replace damaged boot, paying attention to the correct seating.
4
Pull off rubber mount (7b) with grooved ball bearing (8)
NOTE: Installation: Press rubber mount with grooved ball bearing onto joint fork.
5
Press deep-groove ball bearing (8) out of rubber mount (7b) of propeller shaft
Inspect
6
Check boot (4), rubber mount (7b) and grooved ball bearing (8)
-
Check for wear and if there is a complaint replace defective parts.
7
Install in the reverse order.
AR41.10-P-0100-7I Pulling Off Rubber Mount With Grooved Ball Bearing
AR41.10-P-0100-7I Pulling off rubber mount with grooved ball bearing
Special Tools