GL 320 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) (2009)
/v6-3.0l_dsl_turbo_(642.820)/Page-2820003.png)
Component Identification
Install
1
Assemble hollow cylinder (13), hydraulic hose (14) and hand pump (15).
2
Fit rear plate (N) and rear rubber mount (9) on to the hollow cylinder (13) Feed threaded spindle (12) through the hollow cylinder (13), the rear
plate (N), the rear rubber mount (9) and the rear axle carrier (11), screw on nut block (F).
Be careful when screwing on the nut block (F). Otherwise the paint work on the rear axle carrier (11) can be damaged.
3
Align rear rubber mount (9) with the markings and press in.
Use lubricant
The pressure in the hand pump (15) must not exceed 140 bar.
