GL 320 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) (2009)
8. Affix felt tape (A, Figure 4) onto vehicle body edge, to avoid possible wiring harness chafing.
Note:
On vehicles with cargo compartment package (code 942), cut tape in half and affix half of felt tape to cargo rail bracket (B, Figure 4) and the other half
to body edge (A).
9. Attach cable tie (arrow, Figure 4) to SAM bracket then secure wiring harness to SAM bracket using cable tie (D, Figure 3).
Note:
^ On vehicles with BLUETEC (code U42), unclip existing cable tie (A, Figure 5) from body edge then secure wiring harness to body edge with an
additional cable tie (arrow) (refer to parts table).
^ Leave old cable tie (A) connected to harness
10. Remove left and right rear tail lamp units (AR82.10-P-4905GZ).
11. Remove seals from rear tail lamp units and clean mating surface of tail lamp units with cleaner.
Note:
Clean tail lamp mating surface with Terostat - 8550 cleaner or equivalent.
CAUTION!
Do not use cleaner that is harmful to paint or tail lamp unit (e.g., alcohol based cleaner or solvent cleaner must not be used).