GL 320 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) (2009)
Component Identification
Pushing off
1
Unscrew self-locking nut from tie rod joint (1).
2
Mount thrust piece.
3
Press off tie rod ball joint (1) using puller (4) and press.
Do not damage rubber boot (2) as lubricant would escape from the tie rod ball joint (1). This results in increased wear. Fit puller (4) carefully
otherwise the stainless steel race (3) will be damaged.
4
Remove puller (4), press and thrust piece.
Installation
5
Clean tapered connection.
The cone and thread must be free of grease and oil
6
Replace self-locking nut and tighten. If necessary, counter hold the ball head of the tie rod ball joint (1) using the Allen wrench.
AR46.40-P-0400-01GH Detaching and Attaching Inner Clamp
AR46.40-P-0400-01GH Detaching and attaching inner clamp
Component Identification
Remove
1
Remove inner clamping collar (11a) with side-cutting pliers.