GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) (2010)
/v6-3.0l_dsl_turbo_(642.820)/Page-2251005.png)
Detachable Components, Underride Guard
Repair Materials
Parts Ordering Notes
AZ82.10-P-0015-02GZ Retrofit Wiring Harness For Running Board Illumination
AZ82.10-P-0015-02GZ Retrofit Wiring Harness For Running Board Illumination
Repair Materials
The installation of the wiring harness for light emitting diode (LED) lamps, wheel arch is described in steps 1 to 5 on the left-hand side of the vehicle.
Installation on the right side of the vehicle is performed in the same way.
1
Connect black 2-pin coupling (15) of wiring harness for LED lamps, wheel arch (4) with black 2-pin connector (14) of wiring harness for LED
lamps (3).
2
Place wiring harness for LED lamps (3), as shown, in running board (1) area at rear in a loop and attach to inside of running board (1) by applying
felt tape to it (arrow A).
This should ensure that the running board (1) can be removed and installed without removal of the fender liner in the rear fender.
3
Attach wiring harness for LED lamps, wheel arch (4) using felt tape (16) to body.
